4.1 How to Use the Gateway Parameter Configuration Tool
B4-13
ME0384-4A
Chapter 4 Network Configuration
[If connection is not possible due to a communication port open error]
(1) Change the port number on the "Setting" → "Setting of communications" screen on the
"Parameter configuration tool " main screen so that it is the same as the COM No. on the
Device Manager screen on Windows.
(2) Click on the "Parameter configuration tool" main screen to reconnect with the
RCON gateway unit.
This concludes the installation of the USB driver.
"Parameter configuration tool " main screen
Click
PC Windows side: Set in item
8
Displayed on the "Device manager" screen
Gateway parameter configuration tool side:
"Setting of communications" screen
"Parameter configuration tool" main screen
Change to the
same COM No.
Click
Click
To Next Page
Loading...
Need help?
General
