1.1 Periodic Inspection
C1-1
ME0384-4A
Chapter 1 Maintenance and Inspection
1.1 Periodic Inspection
In order to use the RCON system functions in the best possible condition, it is necessary to
perform daily or periodic inspections.
Refer to an instruction manual for each ELECYLINDER for the maintenance for ELECYLINDER.
Danger
● Do not touch the terminal while live. This may result in electric shock.
● Connect the absolute battery correctly. Do not charge, disassemble, heat, throw into fire,
short-circuit or solder. Incorrect handling of the absolute battery may cause injury or fire
due to heating, rupturing or ignition.
●
Always shut off the RCON system power supply before cleaning or assembling/disassembling
the unit. Electric shocks may result if the power is not shut off.
● Malfunctions may result if the unit connections are tightened loosely.
Caution
● Do not disassemble or modify any unit. This may result in breakdowns, malfunctions,
injury or fire.
● Always shut off the RCON system power supply before attaching or removing modules
or motor/encoder cables. If not shut off, module breakdowns or malfunctions may result.
● Do not apply shocks to or drop the absolute battery.
Drops and shocks can damage the absolute battery, causing the liquid inside to leak. If
the absolute battery is dropped or suffers impact, do not use and instead discard.
● Before touching a unit, always touch a grounded metallic part to discharge any static
electricity accumulated on the body. If static electricity is not discharged, module
breakdowns or malfunctions may result.
To Next Page
Loading...
