Table 26. Factory default settings (continued)
Restored Item Default Setting* Comments
OCP Access PIN Disabled
Note: The initial Factory Default
setting is disabled. If the OCP Access
PIN setting is changed, running
"Restore Defaults" does not change
the setting.
If OCP Access PIN is enabled, the
default PIN is "1234".
SSL for Web Disabled
Drives
Power Power On (All drives)
Drive 1 SCSI-ID 4 SCSI Drives
Drive 2 SCSI-ID 5 SCSI Drives
Drive 3 SCSI-ID 6 SCSI Drives
Drive 4 SCSI-ID 8 SCSI Drives
Drive 1 Loop-ID 4 FC Drives Arbitrated Loop
Drive 2 Loop-ID 5 FC Drives Arbitrated Loop
Control Path Drive Drive 1 only
Speed Auto FC Drives (all)
Topology LN-Port FC Drives (all)
IPv6 Stateless Autoconfig Enabled
Note: * = all settings at library firmware level 4.xx and greater
In some cases (such as Library Mode), the entry of one option precludes any other options from being
selected. In such cases, the details of the non-applicable options are not shown.
Configure: Set Date and Time
Use this menu item to set the date and time in your library.
Configure: Path Failover
Use this menu item to enter the Path Failover Feature Activation key (Supported on 4U library only for
library firmware levels at or below 8.xx. Supported on both the 2U and 4U libraries with library firmware
levels above 8.xx).
Configure
Setî˜ Date
and Time
a77ug046
Figure 82. Configure: Set Date and Time menu
Operations 107
To Next Page
Loading...
Need help?
General
