Configure Library menu
The Configure Library menu contains the following submenu items:
v “Configure Library: General”
v “Configure Library: Logical Libraries” on page 124
v “Configure Library: Path Failover” on page 125
v “Configure Library: Encryption” on page 125
v “Configure Library: Drives” on page 127
v “Configure Library: Network” on page 129
v “Configure Library: User-Defined Certificate” on page 131
v “Configure Library: IPSec” on page 135
v “Configure Library: User Access” on page 145
v “Configure Library: Date & Time” on page 147
v “Configure Library: Logs & Traces” on page 147
v “Configure Library: Event Notification” on page 148
v “Configure Library: SNMP” on page 149
v “Configure Library: Save/Restore” on page 150
Configure Library: General
On this page, you can change general library configuration elements. As changes are made, they are
applied only after Apply Selections or Submit is selected. After the selection is made, a warning page
informs you of the impact of the proposed change. In some cases, a pop-up screen asks for confirmation.
Many changes also require a library reboot.
Table 32. Configure Library: General page elements
Menu Item Description 2U 4U
Library Name Enter the name of the library. X X
I/O station
Enabled
The I/O station defaults to I/O station Enabled. Choosing Disabled (no
check mark) adds one more storage slot to the 2U library, and three more
storage slots to the 4U library. When the I/O station is disabled,
removing, or adding media to the library must be completed by releasing
the left or right magazine.
X X
Auto Clean
Enabled
Auto Clean defaults to Disabled. For Auto Clean to function, a cleaning
cartridge (CLNxxxLx) must be resident in a reserved library slot and
Auto Clean must be enabled (turned on).
Note: If Auto Clean is enabled, and a cleaning cartridge is not resident in
a reserved slot, the Auto Clean Status field in the web System Status
screen posts a Chk Media/Rsvd Slot? message.
X X
Bar Code Label
Length Reported
To Host
The default bar code label length is 8, but can be set to 6. The bar code
label length is a "reported" length. This setting causes the host computer
to see only the first 6 characters of the label or all 8 characters. This
setting does not affect the bar code label that is shown on any of the
library user interfaces (always shows all 8 characters).
X X
Table 33. Configure Library: Specific page elements
Menu Item Description 2U 4U
Library Mode Choices are Random and Sequential. If you choose Sequential, you might
also activate Autoload or Loop. If there is more than one logical library, a
Library Mode entry appears for each logical library.
Important: A Logical Library in Sequential Mode supports only one tape
drive. If it contains more than one drive, only the first drive in the
Logical Library is used and the other drives are not supported.
X X
Operations 123
To Next Page
Loading...
Need help?
General
