Important: The Advanced Encryption Settings are for Engineering Support use only. These fields must
always be set to "No Advanced Setting".
For information on minimum firmware levels for Application Managed and Library Managed Encryption,
see “Minimum firmware levels for common library features” on page v.
Setting or Changing a Drive's Method of Encryption
1. Enter your library's IP address in an internet browser address field and press ENTER.
2. Log in to the Web User Interface. See “Login” on page 22.
3. Expand Configure Library in the left navigation panel.
4. Click Encryption.
5. On the Encryption screen, enter the Feature Activation Key to enable the library-managed and the
system-managed encryption options.
6. Click Activate to save the key and expand the screen for more encryption settings.
7. Select Enable SSL for EKM to enable Secure Sockets Layer for the IBM SKLM application.
8. Select an Encryption method, from the pull-down menu, for each logical library.
Figure 102. Feature Activation Key screen
Figure 103. Configure Library: Encryption feature configuration screen
126 IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
To Next Page
Loading...
Need help?
General
