10. Enter IPv6 settings (if applicable).
a. Enable DHCP - Click this item ON to have the IP address of your library automatically set by
the DHCP server.
b. Enable Stateless Auto Config - Click this item ON to have the IP address of your library that is
automatically set by the network router.
c. Static address - Enter the assigned IPv6 address. The format of an IPv6 IP address is a 128-bit
numeric address written as 8 groups of four numbers that are separated by colons.
d. Prefix length - The default prefix length is set to 64, but can be set to any length, depending
upon the address used.
e. Gateway address - Enter the assigned IPv6 Gateway address. This address allows access outside
the local network.
11. Click one:
v Refresh - to cancel the changes that are made to the screen.
v Submit - to apply the changes that are made to the screen.
Note: Depending on the changes that are made, you are either disconnected and must log in again,
or reboot the library. If a reboot is required, the Warning message displays after the Submit button is
clicked.
The library must be rebooted or the changes do not take place.
Entering user access information with the Web User Interface
About this task
The Configure Library > User Access page is only accessible to the Admin and Service login. Access is
denied to User and Superuser logins.
The Admin login has access to all library functions except Service Library > Advance Diagnostics.
The Service login has access to all library functions including Service Library > Advance Diagnostics.
Procedure
1. Click Configure Library > User Access in the left navigation pane.
Figure 50. Warning screen
68 IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
To Next Page
Loading...
Need help?
General
