Table 37. IKE settings (continued)
Name of setting Available values Comments
Host Authentication ID
v All
v IPv6 Address
v FQDN
v E-Mail-Address
ID value that is compared against the
peer ID.
v All
Any peer ID is accepted.
v IPv6 Address
Peer IP address is compared.
v FQDN
Peers FQDN ID is compared.
v Email Address
Peers email address is compared.
8. Certificate Upload
The file selection box displays under the IPSec page, and it is available even before a new policy is
created.
9. Security Association Settings
The Security Association settings define the parameter and algorithms for the Security Association
(SA) used in an IPSec session in case the associated policy is used. In case IKE is not used, these
settings must be the same as on the peer side. If IKE is used, only the AH/ESP selection and the
algorithms are needed.
Table 38. Security Association settings
Name of setting Available Values Comments
Enable AH checked/unchecked AH (Authentication Header) mode
activation
Figure 121. Certificate Upload
Figure 122. Security Association settings
Operations 143
To Next Page
Loading...
Need help?
General
