1. Click Configure Library > Network in the left navigation pane, to display the Network page.
Important: Do not click Submit until all changes are made to the Network page. Once Submit is
clicked, no other changes are made until after the library applied the current changes.
After Submit is clicked, depending on the changes that are made, you are either disconnected and
need to log in again or reboot the library.
Click Refresh to refresh the page and any changes that are made are not retained.
2. Select a Protocol Stack - Choose IPv4 only, IPv6 only, or Dual Stack IPv4 & IPv6.
If you choose Dual Stack IPv4 & IPv6, you must be prepared to enter both IPv4 and IPv6 IP
addresses. The sections gray out depending on the choices that are made here.
3. Enter the Host Name.
Note: The underscore (_) is not allowed as part of a host name.
4. Enter the Domain Name.
5. DNS Primary - Enter the IP address of your primary DNS server.
6. DNS Secondary - Enter the IP address of your secondary DNS server.
7. Enable SSL for Web - If you want to have SSL (Secure Sockets Layer) enabled, place a check mark
in this box.
Note: If you get a security certificate alert when you log in to the Web User Interface, you can install
the certificate or allow an exception (depending on the internet browser you are using). SSL is
enabled when the URL begins with https:// and some browsers show a lock.
8. Ethernet Settings - Ethernet Settings choices are Auto (the default), 10 Mbit/Half, 10 Mbit/Full, 100
Mbit/Half, 100 Mbit/Full.
9. Enter IPv4 settings (if applicable).
a. Enable DHCP - Click this item ON to have the IP address of your library automatically set by
the DHCP server.
b. Static Address - Enter the assigned IPv4 address. The format of an IPv4 IP address is a 32-bit
numeric address that is written as four numbers separated by periods.
c. Network Mask - Enter the assigned IPv4 Network Mask.
d. Gateway address - Enter the assigned IPv4 Gateway address. This address allows access outside
the local network.
Figure 49. Configure Library: Network page
Installation and configuration 67
To Next Page
Loading...
Need help?
General
