▌1▐ Loader motor worm gear ▌3▐ Takeup reel motor
▌2▐ Outer guide rail (WARNING: Do
Not Touch)
▌4▐ Supply reel motor
7. Go to “Ending procedure” on page 283.
Full height drive: Tape tangled along tape path
About this task
Note: If the cartridge in the drive is an INPUT tape that contains ACTIVE or 'ONLY COPY' data (there is
no backup), eject commands that are issued at the host fail to unload the tape, and power-cycling the
drive fails to eject the cartridge, make no further attempts to unload this tape. Call Technical Support
and open a PMR if one is not already open, to initiate the process of sending the drive with the loaded
cartridge in for recovery.
Procedure
1. Carefully pull out excess tape and untangle.
Note: If you find the tape to be broken, go to one of the following appropriate procedures:
v “Full height drive: Tape spooled off supply reel” on page 265
v “Full height drive: Tape pulled from or broken near leader pin” on page 268
--OR--
“Full height drive: Tape broken in mid-tape” on page 271
Figure 207. Rewinding tape into cartridge
Appendix A. Information for trained service personnel 273
To Next Page
Loading...
Need help?
General
