3. Press the SELECT button to apply the new state.
Entering numerical values
About this task
Numerical values are needed for network addresses, password entries, and other configuration entries.
Procedure
1. After navigating to the menu item, the current value is displayed and the cursor highlights the first
digit of the value that can be changed.
2. For each digit to be changed in the value:
a. Use the UP and DOWN buttons to increment / decrement the digit.
b. Press the SELECT button to highlight the next editable digit.
3. Press the SELECT button at the last digit to apply the complete entry, or press the CANCEL button to
cancel the edit process and maintain the original value.
Power ON/OFF
Part of the Operator Control Panel is the Power ON/OFF button. If the library is powered ON, pressing
this button for 4 seconds initiates a controlled power down of the library. The following operations take
place before the library shuts down completely:
v The display indicates with an appropriate message that the shutdown is in progress.
v The library controller finishes all ongoing library and drive activities.
v The accessor is moved to its home position.
v The library controller switches OFF the power supply's secondary side.
Note: The shutdown process is stopped by releasing the button before 4 seconds passes.
Web User Interface
Many of the same operations that are completed from the Operator Control Panel are also completed
remotely with the Web User Interface.
Choose the Web User Interface to monitor and control your library from any terminal that is connected to
your network or through the World Wide Web (WWW). The Web User Interface hosts a dedicated,
protected Internet site that displays a graphical representation of your library.
For static IP addresses only: After a connection to the library is established, open any HTML browser and
enter the IP address of the library. To configure the Web User Interface, you must first set the IP address
with the Operator Control Panel. Refer to “Configure: Network” on page 103 or “Configure Library:
Network” on page 129.
Login
Important: Some options of the Web User Interface take the library offline. This inactive mode interferes
with host-based application software, causing data loss. Make sure that the library is idle before you
attempt to complete any remote operations that take the library offline.
To log in, select the Role type and enter the correct password. There are four levels of access:
v User - Normal user level. The User has access only to Monitor Library menus.
v Superuser - The Superuser has access to the Monitor Library and Manage Library sections.
v Admin - Admin user level The Admin user has access to all menus except those menus that are
restricted to Service only.
22 IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
To Next Page
Loading...
Need help?
General
