Important:
v IKE-enabled configurations need a running Racoon2 or StrongSwan system that is correctly configured
to match your policy.
v SPI-enabled configurations need a correct setkey setup.
v When SPI and IKE-enabled configurations are mixed, be careful to set up the right configuration.
Common preferences
v Default policy supports discard and bypass mode.
v It is not possible to save more than four policies.
Single policy configuration
v Multiple single addresses per policy are not provided.
v The SPI index must be 256 - 10000 for a pure SPI connection.
Configure Library: User Access
This page allows the user to add and modify user accounts. See “Login” on page 22 for information
about user types.
The Configure Library > User Access page is accessible only to the Admin and Service login. Access is
denied to User and Superuser logins.
The Admin login has access to all library functions except Service Library > Advance Diagnostics.
The Service login has access to all library functions including Service Library > Advance Diagnostics.
Figure 123. Policy slot setup after one policy is saved
Operations 145
To Next Page
Loading...
Need help?
General
