15. “Configuring SNMP settings” on page 71
16. “Testing encryption configuration for Library Managed encryption” on page 73
17. “Restoring factory default settings” on page 73
18. “Logging out of the Web User Interface” on page 25
19. “Setting the Operator Control Panel Access PIN” on page 104
Establishing remote access to your library
About this task
Static library network settings must be entered with the Operator Control Panel before the library is
accessed remotely with the Web User Interface. If your system is serviced by DHCP (Dynamic Host
Configuration Protocol) server, the network parameters are automatically set. When remote access is
established, you can complete the configuration of your library with the Web User Interface.
Procedure
1. Access the Configure menu with the Operator Control Panel.
a. From the screen that shows the library logo (Home screen), press either the UP or DOWN button
to get to the main menu.
b. Press DOWN to select Configure.
c. Press SELECT to display the Configure menu.
2. Press DOWN to highlight the Network menu.
3. Press SELECT to display the Network screen.
4. Select IP STACK, and press SELECT to highlight the Internet Protocol field.
a. Press DOWN or UP to scroll through the Internet Protocol options.
b. Press SELECT on the wanted Internet Protocol.
If you select IPv6 protocol, the Configure Network menu includes options for Stateless Autoconfig
and Prefix length.
v Stateless Autoconfig:
– Press DOWN to highlight Stateless Autoconfig.
– Press SELECT to highlight the Stateless Autoconfig option field.
– Press DOWN to scroll through the Stateless Autoconfig options.
– Press SELECT to apply the option.
v Prefix Length:
– Press DOWN to highlight Prefix Length.
– Press SELECT to highlight the Prefix Length option field.
– Press UP or DOWN to scroll through the Prefix Length digits.
– Press SELECT to apply the Prefix Length digits.
5. Complete the following steps to select DHCP for your library. Skip this step and proceed to the next
step if you do not want to select DHCP as your library network setting.
a. Press DOWN to highlight DHCP.
b. Press SELECT to highlight the DHCP field.
c. Press DOWN to select ON.
d. Press SELECT to apply your selection.
e. Skip to Step 7.
6. Press DOWN to select IP Address. For IPv4 only, enter an IPv4 address. For IPv6 only, enter an IPv6
address. For IPv4 & IPv6, enter an IPv4 address and an IPv6 address.
a. Press SELECT to highlight the IP address field.
b. Press UP or DOWN to select the digitsin the first octet of your library's IP address.
58 IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
To Next Page
Loading...
Need help?
General
