Important: Operating your library on a flat surface without foot pads might damage your library or
cause it not to function properly.
v Rack mount - temporary placement of the foot pads
v Desktop - permanent placement of the foot pads
a. For a rack mounted library:
1) Lift the replacement library enclosure slightly above the work surface. Then, have another
person place a foot pad under each corner of the library and on each side of the library
halfway between the front and back.
2) Gently set the replacement library enclosure on top of the feet. Adjust foot pad placement as
necessary to stabilize the library. Do not permanently attach the foot pads to the library.
b. For a desktop library:
1) Carefully lay the library on its side.
2) Peel the adhesive from the back of each of the 6 foot pads.
3) Install the foot pads on the bottom of the library enclosure by pressing each foot into one of
the six areas (▌1▐) as shown in Figure 179.
3. Carefully return the library to an upright position.
Figure 179. Foot pads that are installed on the bottom of the library enclosure
236 IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
To Next Page
Loading...
Need help?
General
