Problem Action Required
Bad media
1. Go to Monitor > Inventory to locate the defective
cartridge.
2. Move the defective cartridge to the I/O Station.
(Operator Control Panel: Control > Move
Cartridges).
3. Open the I/O Station to remove the defective
cartridge. (Operator Control Panel: Control > Open
I/O).
Drive sled issues Do one of the following procedures:
- Install a drive sled (see “Removing/installing/adding a
tape drive sled” on page 223).
- Modify or resubmit Logical Library setting (Operator
Control Panel: Configure > Logical Libraries or Web
User Interface: Configure Library > Logical Libraries).
- Restore defaults (Operator Control Panel: Configure >
Restore Defaults or Web User Interface: Configure
Library > Restore Defaults).
Redundant power supply failed Complete the following steps:
1. Replace the failed power supply (see “Replacing a
power supply” on page 231).
2. Cycle library power.
Power supply fan failure Replace the power supply.
v The Error LED is illuminated when there is an unrecoverable (that is, hard) drive or library failure.
This error happens at the same time the hard error message is displayed on the screen and the LED
remains lit until the error state is resolved.
Note: From the Operator Control Panel, run Service > Library Verify. If Library Verify runs without
error, the Error LED turns off. If the error persists, recycle power.
Input modes
There are several ways to enter values in the different menu items. These values are selectable predefined
values, toggle values (for example, ON/OFF), and numerical values like network addresses.
Selecting predefined values
Procedure
1. To set the predefined values, press the SELECT button to select the menu item.
2. Using the UP and DOWN buttons, select one of the various predefined values for that item.
3. As soon as the Operator Control Panel display shows the correct value, press the SELECT button to
apply the value.
Toggling values
About this task
Toggle values are used to switch between two different states like ON and OFF.
Procedure
1. After navigating to the menu item, press the SELECT button to select the menu item.
2. With the UP and DOWN buttons, select one of the various predefined states for that item.
User interfaces 21
To Next Page
Loading...
Need help?
General
