– Lower the four leveling pads.
– Install stabilizer brackets on the rack cabinet.
– If you removed any devices from the rack cabinet, repopulate the rack cabinet from the lowest
position to the highest position.
v If a long-distance relocation is required, restore the rack cabinet to the configuration of the rack cabinet
as you received it. Pack the rack cabinet in the original packaging material, or equivalent. Also, lower
the leveling pads to raise the casters off the pallet and bolt the rack cabinet to the pallet.
(R002)
Power Cords
For your safety, IBM provides a power cord with a grounded attachment plug to use with this IBM
product. To avoid electrical shock, always use the power cord and plug with a properly grounded outlet.
IBM power cords used in the United States and Canada are listed by Underwriter’s Laboratories (UL)
and certified by the Canadian Standards Association (CSA).
For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified cord set consisting of a
minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length and a parallel
blade, grounding-type attachment plug rated 15 amperes, 125 volts.
For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in
length and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts.
For units intended to be operated at 230 volts (outside the U.S.): Use a cord set with a grounding-type
attachment plug. The cord set should have the appropriate safety approvals for the country in which the
equipment will be installed.
IBM power cords for a specific country or region are usually available only in that country or region.
Cautions and regulatory compliance statements for NEBS
This library is NEBS certified. This section includes the cautions and regulatory compliance statements for
the Network Equipment-Building System (NEBS) certification from the Telcordia Electromagnetic
Compatibility and Electrical Safety - Generic Criteria for Network Telecommunications Equipment (A
Module of LSSGR, FR-64; TSGR, FR-440; and NEBSFR, FR-2063) Telcordia Technologies Generic
Requirements, GR-1089-CORE, Issue 4, June 2006.
NEBS Compliance Statements
CAUTION:
To comply with the Telcordia GR-1089-CORE standard for electromagnetic compatibility and safety,
for Ethernet RJ-45 ports, use only shielded Ethernet cables that are grounded on both ends. In a NEBS
installation, all Ethernet ports are limited to intra-building wiring.
Safety and environmental notices xxv
To Next Page
Loading...
Need help?
General
