73P5 /or the library firmware is equal to or lower than 1.95. For either or both of these two cases, the
device driver interface Data Path failover key activation is still required.
3. Click Activate to save the feature key. The following screen displays if you correctly entered the
feature key.
Setting up encryption
About this task
Note: Application Managed Encryption (AME) does not require a key. Library Managed Encryption
(LME) and System Managed Encryption (SME) require a license key that is available by purchasing
Feature Code 5900.
For information on minimum firmware levels for Application Managed and Library Managed Encryption,
see “Minimum firmware levels for common library features” on page v.
Important: The Advanced Encryption Settings are for Engineering Support use only. These fields must
always be set to "No Advanced Setting".
Setting a drive's method of encryption
1. Click Configure Library > Encryption in the left navigation panel.
2. On the Encryption screen, enter the Feature Activation Key to make available the library managed
and the system managed encryption options.
3. Click Activate to save the key and expand the screen for more encryption settings.
Figure 45. Feature key verification screen
Figure 46. Feature activation key screen
64 IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
To Next Page
Loading...
Need help?
General
