a. With the Web User Interface, select Manage Library > Move Media. If the cartridge is not in an
I/O station slot, move the cartridge to an I/O station slot.
b. With the OCP, select Control > Open I/O Station.
4. Remove cartridge. If cartridge was reported as Bad, properly dispose the cartridge.
5. Close the I/O station. If the amber LED was lit because of bad media, the Attention LED turns OFF.
If the amber LED is still on, check the power supply or the power supply fans. See “Isolating a power
supply problem” on page 194.
200 IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
To Next Page
Loading...
