ICON A5 - Page 332

9-96 FLIGHT CONTROLS / YAW CONTROLS
ICON A5 / MAINTENANCE MANUAL CHANGE C3
CHAPTER 9
FIGURE 9-61
RUDDER MEASUREMENT PLANE
17. Adjust rudder push tube length to set the neutral position of the rudder to be 1°+/-1° trailing edge
right. This must be done by removing the AN3C7A bolt that secures the FWD side of the push
rod and adjusting the rod end. See Figure 9-62.
(66.04°)
Rudder Axis
Measurement
Plane
Measurement
Point
Rudder