14-74 LANDING GEAR / NOSE LANDING GEAR
ICON A5 / MAINTENANCE MANUAL CHANGE C2
None
Parts Required
None
Aircraft System and Number
11—Landing Gear
Consumables
None
1. Remove left, center, and right instrument panels tops to again access to the landing gear actu-
ator.
2. Lift the nose of the aircraft and support as required (by the keel).
3. Disconnect the forward attachment bolt of the actuator and retain hardware.
4. Loosen the clamp (30-45/9-W5) that connects the NLG Actuator Boot to the nose landing gear
box. Slide the boot off the NLG box. Retain all hardware.
5. Loosen the Mini Worm Drive Clamp that connects the NLG Actuator Boot the forward side of the
NLG actuator. Retain all hardware.
6. Disconnect the aft connection point of the actuator from bracket attached to the nose landing
gear box. Retain all hardware.
7. Disconnect the actuator connector from the FWD Fuselage Wire Harness.
8. Remove the actuator from the aircraft by sliding it out of the nose landing gear box.
VERIFICATION METHOD:
The procedure is complete when the actuator has been removed.
14.7.2.7.2 Nose Landing Gear Actuator Installation and Rigging
Use the following task to install and replace the nose landing gear actuator. For rigging only, proceed
to step five.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
A&P
Task Specific Training Required
No
To Next Page
Loading...
