ICON A5 - Page 748

17-16 WING / WING GENERAL MAINTENANCE
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 17
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
14—Wing
Consumables
LOCTITE
®
243™
TASK INSTRUCTIONS:
1. Use a 5/16 wrench to remove the ICA010126 wing hang pin from its receptacle in the horizontal
tail, turning it like a bolt.
2. Apply LOCTITE
®
243™ to the threads of the replacement pin and thread it into the receptacle in
the horizontal tail. Torque to 105 in-lb
f
.
VERIFICATION METHOD:
The procedure is finished when all the steps have been completed.
17.3.7 Wing Trailing Edge Light Fence Replacement
Use the following procedure to replace the trailing edge light fence.
TASK INFORMATION:
Type of Maintenance