18-10 WING FOLD MECHANISM / TROUBLESHOOTING
ICON A5 / MAINTENANCE MANUAL CHANGE C0
5. Apply a thin coat of MOLYKOTE™ G-4700 to the wing pins, bushings, and locking pins.
VERIFICATION METHOD:
If the wing pin dimensions are above the target values and the bushing dimensions are below the target
values, then the wing pin fit is acceptable. If not, then contact ICON Aircraft for further information.
Any cracks found in the wing pins or bushings should be investigated further. Do not fly the airplane
and contact ICON for further instructions.
If the wing locking pin dimension is above the target values, then the locking pin fit is acceptable. If not,
replace all wing locking pins below the target values.
RELATED INFORMATION:
"Condition and 100-Hour Inspection—Wings" on page 3-11
Name/Part Minimum Diameter (in)
Forward Wing Locking Pin Ø 0.3035
Aft Wing Locking Pin Ø 0.2400
To Next Page
Loading...
