20-6 STRUCTURAL REPAIR / GENERAL BONDED FASTENER REPLACEMENT
ICON A5 / MAINTENANCE MANUAL CHANGE C0
Aircraft System and Number
Consumables
None
The new fastener must be selected and located in accordance with the appropriate supporting docu-
mentation. Contact ICON Owner Support if lacking definition of what fastener to use or where to place
it.
1. Prepare and clean the substrate in the area to be bonded in accordance with the Click Bond
®
CBPS-206 Rev. E procedure.
2. Loosely install the replacement fastener in the location specified by the appropriate supporting
documentation and verify fit.
3. Apply CB200 adhesive to the fastener in accordance with Click Bond
®
procedure CBPS-206
Rev. E.
VERIFICATION METHOD:
Once the CB200 cures, remove fixturing and inspect the fastener for security and complete adhesive
squeeze out.
RELATED INFORMATION:
"General Bonded Fastener Replacement" on page 20-3
To Next Page
Loading...
