iPECS eMG80 - Differential Ring

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
95
2.29 Dial Pulse to Tone Switchover
Description
On a pulse dial outside Line, you can request the system to change the signaling mode from
pulse to DTMF. This allows you to access outside facilities that require DTMF signals such as
banking services, Voice mail, etc.
Operation
1. Dial “*”, the signaling changes to DTMF.
To switch from pulse to DTMF while on a pulse Line
Conditions
1. This command is only recognized for analog pulse dial CO lines.
2. Dial pulse to tone switchover is not available in the Redial features.
3. When the system encounters an “*” in a Speed Dial digit string, dialing will pause then
the remaining digit are sent using DTMF signaling.
4. For VoIP calls, pulse dialing is not available thus; switchover is not required or
supported.
Programming
Keyset Admin.
CO/IP CO Line Type (PGM 141-Button 4)
CO Line Signal Type (PGM 141-Button 5)
CO LINE DATA
Web Admin.
Common Attributes CO Line Type
Analog Attributes

CO Line Signal
SYSTEM DATA
System Attributes

First digit * in SPD
elated Features
 Speed Dial
 Display Security
Hardware