iPECS eMG80 - Station Flexible Button Default Table

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
223
2.75.4 System Speed Dial
Description
Commonly dialed numbers can be stored by the System Attendant or by the Administrator in Web
Admin for easy access by stations allowed use of System Speed Dial bins. With eMG80, up to
3000 System Speed Dial numbers are available and with eMG800, up to 8000 System speed dial
numbers are available and with UCP, up to 1200 systems speed dial numbers are available.
Each Speed Dial number can be up to 25 characters in length and may include special instruction
codes.
Special instruction codes available are:
‘*’ as 1st digit
Activate Display Security.
‘*’ not 1st digit
Switch from Pulse to DTMF dialing.
[DND]
Insert a Flash command.
Flash as 1st digit
Activate dial tone detect.
[MESSAGE/CALLBACK] as 1st digit
Activate ISDN Keypad Facility
[MESSAGE/CALLBACK]
Insert a pause dialing command.
You may assign a Flex button of your iPECS IP or LDP Phone for One-Touch access to a
specific System Speed Dial bin.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + [SPEED] + System Speed Dial bin number + [HOLD/SAVE]
To assign a Flex button as a {SYSTEM SPEED DIAL} button
1. Lift handset or press the [SPEAKER] button.
To dial using a System Speed Dial using a [SPEED] button
2. Press the [SPEED] button.
3. Dial the desired bin number (eMG80:2000-4999 / eMG800: 2000-9999 / UCP: 20000-
31999).
1. Press the [DIR] soft button.
To dial a System Speed Dial number using an LIP-8000/LIP-9000 series phone with soft
buttons
2. Press the [SPEED] soft button.
3. Dial the desired bin number (eMG80:2000-4999 / eMG800: 2000-9999 / UCP: 20000-
31999).
SLT
1. Lift handset.
To dial using a System Speed Dial
2. Dial “*558”, the SLT Speed Dial access code.