iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
284
2.86 Wake-Up Alarm, Enhanced
Description
If permitted in the system database, you can set up to five (5) Wake-up or alerting time. When a
time is reached, the system will signal your station with an audible and visual signal. The alerting
for each of the 5 Wake-up alarms will repeat based on the type selected when you assign the
alarm.
The alarms will repeat as follows:
Repeat Type Repeating
1 Alarm activates one time at the assigned date and time
2 Alarm repeats daily Monday through Friday
3 Alarm will repeat daily, Monday through Saturday
4 Alarm will repeat daily
A System Announcement can be assigned to play as a Wake-Up announcement when user lifts
the handset in response to the alarm signal. Each station can be assigned a different Wake-Up
announcement, which is recorded by the Attendant.
Operation
Attendant
1. Press the [TRANS/PGM] button.
To register a Wake-Up alarm
2. Dial “044”, the Attendant Set Wake-Up code.
3. Dial the station range to be alerted. If a single station is to receive the alarm, enter “*” as the
second station number.
4. Dial the desired 2-digit hour (24-hour mode), then 2-digit minute for alerting.
5. Enter Repeating type, “1” to “4”.
6. For the one-time alarm (repeating type 1), enter the date for the alarm as 2 digits for year,
month and day of the month.
7. Press the [HOLD/SAVE] button.
1. Press the [TRANS/PGM] button.
To erase Wake-Up
2. Dial “045”, the Attendant Erase Wake-up code.
3. Dial the desired station range, for a single station, enter an “*” as the second station number.
4. Press the [HOLD/SAVE] button.
iPECS IP & LDP Phones
1. Press the [TRANS/PGM] button.
To register wake-up time alarm from a Station, perform the following steps
To Next Page
Loading...
