iPECS eMG80 - Net Intercom Call

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
254
2.82.2.1 Net Intercom Call
Description
You can place calls to stations connected to other networked systems. Station calls across the
network are always terminated in the Tone Ring Intercom Signaling mode. Station calls are
placed in the normal manner by dialing the desired station number or pressing a {Net-DSS}
button.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + Station Number + [HOLD/SAVE]
To assign a Flex button as a {NET DSS} button
1. Lift the handset or press the [SPEAKER] button.
To place an intercom call to a networked station
2. Dial station number or press the {NET DSS} button.
3. Await answer.
SLT
1. Lift the handset to receive ICM dial tone.
To place an intercom call
2. Dial the station number.
3. Await answer.
Conditions
1. A {NET DSS} button LED indicates the status of the associated station.
2. The LCD will display the caller’s Name if Calling Name Identification Presentation
(CNIP) is enabled in the Networking parameters and the caller’s Name is assigned in
their local iPECS system.
3. If no idle path is available over the Network, you will hear error tone.
4. Network Intercom calls always signal in the Tone ring mode and are not subject to
Intercom Caller Controlled ICM Signaling.
5. If a network failure occurs, the system will place an outside call using the Alternate
Speed Dial bin assigned in the Network Numbering Plan that corresponds to the called
user. Note this is not a Distributed Network call and thus features associated with
Networking such as Call Back, are not available.
6. Network Intercom calls are subject to the CO Call Restriction Timer.
Programming
Keyset Admin.
SYSTEM Networking Basic Attribute (PGM 320)
Networking CO Line Attribute (PGM 322)