iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
92
2.28 Dial-by-Name (Directory Search & Dial)
Description
A name, up to 16 characters, may be assigned to each Station and System Speed dial. In
addition, each station may be assigned a 12-character name. When Names are assigned, if using
an iPECS IP or LDP phone, you may place an intercom call to another station or select a Station
or System Speed dial using the Name.
You select from one of three Dial-by-Name directories and enter characters employing 2 dial pad
buttons for each character. The system finds and displays the nearest match to your entries. You
may continue entering characters or scroll the directory at any point using the [VOL UP]/[VOL
DOWN] button and selecting a name to call. The number associated with a selected name is
displayed by using the [TRANS/PGM] button.
Operation
iPECS IP & LDP Phones
1. Press the [SPEED] button twice.
To use Dial by Name using a [SPEED] button
2. Dial the desired directory.
3. Search the directory using the [VOL UP]/[VOL DOWN] button or by entering characters.
See Station Speed Dial for character entry procedure.
4. Press the [HOLD/SAVE] button to place the call.
1. Press the [DIR] soft button.
To use Dial by Name using [DIR] soft button or [Directory] button
2. Dial the desired directory.
3. Search the directory using the Navigation buttons or by entering two digits for each
character, refer to Station Speed Dial for the Character Entry Chart.
4. Press the [HOLD/SAVE] button to place the call.
1. Press the [TRANS/PGM] button.
To toggle between the name and number display
1. Press the [TRANS/PGM] button.
To program your Station User Name
2. Dial “071”, the Attendant User Name Program code.
3. Dial the Station number.
4. Dial the name, up to 12 characters; refer to Station Speed Dial for The Character Entry
Chart.
5. Press [HOLD/SAVE].
To Next Page
Loading...
