iPECS eMG80 - Message Wait;Call Back

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
293
3. INTERCOM
3.1 Barge In
Description
Barge in permits authorized extensions to intrude into other existing outside or intercom calls.
When you intrude on an existing call, a Conference is established with you (the supervisor) and
the parties on the existing call.
Barge-in from your phone is assigned for one of three operating modes:
(0) – Barge in is disabled
(1) – Barge in Monitor mode, the intruding station can listen only
(2) – Barge in Speech mode, the intruding station hears the conversation and may join
and may join the conversation to speak to the other parties.
Operation
iPECS IP & LDP Phones with 3-soft buttons
1. Call the busy station and receive busy tone.
To Barge-in in the Monitor mode
2. Press the [MONITOR] soft button. You will need to use the right Navigation button to
display the Monitor selection.
3. Warning tone is sent to the connected parties and you are connected to the call in a “listen-
only”, monitor mode.
1. Call the busy station and receive busy tone.
To Barge-in in the Speech mode
2. Press the [MONITOR] Soft button. You will need to use the right Navigation button to
display the Monitor selection.
3. Warning tone is sent to the connected parties and you are connected to the call in a “listen-
only”, monitor mode.
4. If Barge-in Speech mode is assigned, press the [JOIN] Soft button to join the conversation.
The parties receive intrusion tone and you connect to the call.
5. To terminate the call and return the all parties to idle, press the [DROP] soft button.
1. Hang-up the phone.
To exit Barge-in
Conditions
1. This feature is only supported for iPECS IP and LDP Phone models with 3 soft buttons.