iPECS eMG80 - Digit Conversion

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
105
2.31 Digit Conversion
Description
When a system receives digits from station, CO line, the dialed digits are converted according to
the Digit Conversion Table before the Numbering Plan is checked.
When you place an outside call the digits you dial are compared with the Digit Conversion Table.
If a match is found, the digits are converted as defined in the table. Within the table are 15 sub-
tables with up to 200 entries of up to sixteen digits for each sub-table for eMG80. With eMG800
and UCP, within the table are 32 sub-tables with up to 200 entries of up to sixteen digits for each
sub-table
Different conversion can be assigned for the same dialed number based on the system service
mode and LCR configuration. Conversion can also be limited to outside calls from a station or an
outside Line. The latter may be used in networked environments where a system in the network
employs Lines from another system to place a call.
Operation
CO.
Called party(DID) number is changed with digit conversion table.
Then, system analyze converted number with DID process.
Station
Dialed digit from user is changed with digit conversion table.
Then, system analyze converted number with outgoing process.
Conditions
1. Each Station, CO line can have a Digit Conversion Tables.
2. Emergency code takes priority over digit conversion.