iPECS eMG80 - Wake-Up Alarm, Enhanced

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
271
Operation
Conditions
Refer to the External Voice Mail function in the system features.
1. The centralized VM must be configured in the central system to which it is attached as
a Network VM. The Voice Mail Dialing table and other characteristics of the Network
VM are established in the central system.
2. The destination must be defined as part of the network Numbering Plan configuration
for each system that will use the centralized VM except for the central system.
Programming
Keyset Admin.
SYSTEM Network Numbering Plan Table (PGM 324-Button 6)
Station Groups (PGM 190) – Ext AA/VM Group
NETWORKING DATA
Web Admin.
Net Numbering Plan
STATION GROUP
DATA
Station Group Assignment
Station Group Attributes
Related Features
Hardware
2.82.2.14 Networked System Paging
Description
You may have access to the Page Zones of other systems in the network. A warning tone is
provided, if assigned in the networked system, and then you are connected to the Page Zone.
The conditions such as Page Time-out of the networked system will apply to your page.
You can access and make page announcements to stations and external zones of a networked
system by dialing a pre-programmed number or with a Flex button just as if the page was within
the same system.
Operation
iPECS IP or LDP Phone
[TRANS/PGM] + {Flex Button} + Net Numbering Plan code for Page + [HOLD/SAVE]
To assign a Flex button to access a Page Zone in Networked system
1. Lift the handset.
To Page a Networked system Zone