iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
128
2.40 Forced Disconnect Intrusion
Description
You can force a busy outside Line or station to disconnect an active call, and connect to your
phone. Prior to connecting, the outside Line is returned to idle. When connecting to a station, the
station will receive a short warning tone.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + [Flex button] + [TRANS/PGM] + [7#] + [HOLD/SAVE].
To assign a {Forced Release} button
1. Lift the handset or press the [SPEAKER] button.
To activate forced Line disconnect feature
2. Press the busy Line button or dial a Line access code, you will receive busy tone.
3. Press the {Forced Release} button.
4. The call on the busy Line is terminated, the connected station receives error tone and you
are connected to the Line.
Or,
1. Lift the handset or press the [SPEAKER] button.
2. Press the busy Line button or dial a Line access code, you will receive busy tone.
3. Press the [TRANS/PGM] button and dial “*56*”, Forced Channel Seize code.
4. The call on the busy Line is terminated, the connected station receives error tone and you
are connected to the Line.
1. Place an intercom call to the busy station and receive busy tone.
To activate forced intrusion to a busy station feature
2. Press the {Forced Release} button.
3. The call on the busy Station is terminated, the station receives warning tone and you are
connected to the station.
Or,
1. Place an intercom call to the busy station and receive busy tone.
2. Press the [TRANS/PGM] button and dial “*56*”, Forced Channel Seize code.
3. The call on the busy Line is terminated, the connected station receives error tone and you
are connected to the Line.
SLT
1. Lift the handset.
To activate forced Line disconnect feature
To Next Page
Loading...
