iPECS eMG80 - CO Line Flash

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
326
4.3 CO Line Flash
Description
Analog CO Lines recognize a brief open or ground connection, “Flash”, as a request for new dial
tone. When used behind a PBX, a Flash is often used to activate a PBX feature or call transfer.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “94” + [HOLD/SAVE]
To assign a {Flash} Flex button
1. Press the [FLASH] button, the system generates a flash on the analog CO line.
While connected to an analog CO line
SLT
1. Momentarily depress the Hook-switch.
While connected to an analog CO line
2. Dial “*551”, Flash Command To CO Line code, the system generates a Flash on the analog
CO Line.
Conditions
1. Stations may Flash on an analog CO Line defined for PABX operation and will
experience COS (Class of Service) dialing restrictions after a PABX Trunk access
code is dialed.
2. During a Flash, the LED for the Line button will remain lit.
3. A Flash may be stored as a part of a Station or System Speed Dial number.
4. While connected to an internal call or dial tone, activating Flash will return internal dial
tone.
5. While making a Page Announcement, activating Flash will terminate the Page
Announcement and return internal dial tone.
6. The Flash function is not available on ISDN and IP Line calls.
Programming
Keyset Admin.
CO/IP
CO Flash Timer (PGM 142-Button 12)
CO LINE DATA
Web Admin.
Analog Attributes

Flash Timer
Related Features
 Station Speed Dial
 System Speed Dial
Hardware