iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
220
2.75.3 Station Speed Dial
Description
You can store commonly dialed numbers for easy access using Station Speed Dial. With the
system, your station has access to 100 Speed Dial numbers each stored in a “bin”. Each Speed
Dial number can be up to 25 digits in length and may include special instruction codes.
Special instruction codes available are:
‘*’ as 1st digit Activate Display Security, do not display number.
Switch from Pulse to DTMF dialing
Activate dial tone detect.
[MESSAGE/CALLBACK]as 1
st
digit
Activate ISDN Keypad Facility
Insert pause dialing command.
Your iPECS IP and LDP Phone may have a Flex button assigned for One-Touch access to a
specific Speed Dial number. In addition, you may assign a telephone number directly to a Flex
button on your iPECS IP and LDP Phone. In this case, the telephone number is allocated to the
highest numbered Station Speed Dial bin you have available.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + [SPEED] + Station Speed Dial bin number + [HOLD/SAVE]
To assign a Flex button as a {STATION SPEED DIAL} button
1. Lift handset or press the [SPEAKER] button.
To dial using a Station Speed Dial with a [SPEED] button
2. Press the [SPEED] button.
3. Dial the desired bin number (00-99).
1. Press the [TRANS/PGM] button.
To program a Station Speed Dial number using the [SPEED] button
2. Press the [SPEED] button.
3. Dial the Speed Dial bin number (00-99).
4. Press select a Line button or dial a Line access code.
5. Dial the number to be stored.
6. Press the [HOLD/SAVE] button.
7. If desired, enter a name, see alphanumeric entry chart below.
8. Press the [HOLD/SAVE] button.
iPECS IP Phones with 3-Soft buttons
1. Press the [DIR] soft button.
To dial using a Station Speed Dial using an LIP 8000/8000E/LIP-9000 series phones with soft
buttons
2. Press the [SPEED] soft button.
3. Dial the desired bin number (00-99).
To Next Page
Loading...
