iPECS eMG80 - CO Line Flash

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
313
3.10.4 Station Message Wait/Call Back
Description
When a called station does not answer or is in DND, you can activate a Station Message Wait
indication to request a Call Back. A station may receive a Message Wait from any number of
other stations in the system. The station receiving the Message Wait can return the calls using
the [MESSAGE/CALL BACK] button.
When a busy station is called, you may request to be placed in a queue to receive a Call Back.
When the called station returns to idle, the system notifies you with Callback ring. When you
answer, the previously busy station is called.
When a Message is waiting, the [MESSAGE/CALL BACK] button LED of iPECS IP or LDP
Phones flashes and, for properly equipped SLTs, the MW Lamp will flash.
Operation
iPECS IP & LDP Phones
1. Press the [MESSAGE/CALL BACK] button, confirmation tone received.
To leave a Message Wait, while receiving ring back tone or no response on a call announce
2. Hang up, Message Wait activated.
1. Press the [MESSAGE/CALL BACK] button, confirmation tone received.
To leave a Message Wait, while receiving DND tone
2. Hang-up, Message Wait activated.
1. Press the [MESSAGE/CALL BACK] button, the user receives confirmation tone.
To leave a Call Back (queue for a station), while receiving busy
2. Hang up, return to idle.
1. Lift the handset or press the [SPEAKER] button.
To respond to a Call back recall, when the busy station is available the system calls back,
2. Previously busy station is called.
1. Press [MESSAGE/CALL BACK] button, the message contents summary as below or the
Station Messages Waiting list will display.
To retrieve Station Messages Waiting
ST CL VS VM FS MS
001 001 005 006 001 004
2. Dial “1” to select ST (Station Message Wait)
“1” => ST: Station Message Wait
“2” => CL: CLI Message Wait
“3” => VS: Integrated VM Message Wait
“4” => VM: external Voice Mail