iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
108
2.33 Differential Ring
Description
Differential Ring allows any one of 1x (x means the number may be different) different audible
Ring signals to be assigned to iPECS IP and 1x (x means the number may be different) Ring
signals for the LDP Phones, allowing you to determine which phone is ringing and the type of call
(Intercom or external). When the phone receives an incoming call, the selected ring signal is
provided over the speaker. Different selections are assigned for Intercom and outside calls.
Some different tones are stored in the iPECS IP Phones. These tones are permanent while the
others are downloaded from iPECS system.
In addition, each outside Line can be configured to provide one of different ring tones so that you
can determine which outside Line is ringing.
Operation
iPECS IP Phones
1. Press the [TRANS/PGM] button.
To select the desired ring tone
2. Dial “1” for Ring Selection.
3. Dial “1” for Station Ring or “2” for CO Ring.
4. Dial Ring Tone selection, the ring tone is received.
1. Press the [TRANS/PGM] button.
To download a Ring tone from the system to an iPECS IP Phone
2. Dial 1 for Ring selection.
3. Dial 5 for Ring tone download.
4. Dial the Ring tone storage bin.
5. Dial the Ring tone selection, the tone is received.
6. Press the [HOLD/SAVE] button.
LDP Phones
1. Press the [TRANS/PGM] button.
To select the desired ring tone
2. Dial “1” for Ring Selection.
3. Dial “1” for Station Ring or “2” for CO Ring.
4. Dial Ring Tone selection, the ring tone is received.
To Next Page
Loading...
