iPECS eMG80 - Intercom Lock-Out

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
287
2.87 Wake-up Alarm, Standard
Description
The standard Wake-up Alarm feature allows you or an Attendant to set a Wake-up alarm or
desired time to be alerted. When the time is reached, the system will signal your station with an
audible and, for iPECS IP and LDP Phones, a visual signal is provided in the LCD.
A System Announcement can be assigned to play as a Wake-Up announcement when you lift the
handset in response to the alarm signal. Each station can be assigned a different Wake-Up
announcement, which is recorded by the Attendant.
Operation
Attendant
1. Press the [TRANS/PGM] button.
To register a Wake-Up Alarm
2. Dial “044”, the Attendant Set Wake Up code.
3. Dial the desired station range, for a single station, enter an “*” in place of the second station
number.
4. Dial the 2-digit hour and 2-digit minute for alerting.
5. For a daily (repeating alarm), dial “#”.
6. Press the [HOLD/SAVE] button.
1. Press the [TRANS/PGM] button.
To erase Wake-Up
2. Dial “045”, the Attendant Erase Wake-up code.
3. Dial the desired station range, for a single station, enter an “*” in place of the second station
number.
4. Press the [HOLD/SAVE] button.
iPECS IP & LDP Phones
1. Press the [TRANS/PGM] button.
To register Wake-Up
2. Dial “41”, the Set Wake-up code.
3. Dial the 2-digit hour and 2-digit minute for alerting.
4. For a daily (repeating alarm), dial “#”.
5. Press [HOLD/SAVE] button.
1. Lift the handset or press the [SPEAKER] button.
To stop the alarm notification
1. Press the [TRANS/PGM] button.
To erase Wake-Up
2. Dial “42”, the Erase Wake-up code.