EasyManua.ls Logo

iPECS eMG80 - Unsupervised Conference

iPECS eMG80
467 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
84
2.22.5 Unsupervised Conference
Description
Using your iPECS IP or LDP Phone, you may establish a conference with external parties and
exit the conference while allowing the external parties to converse privately without the system
supervising the connection through your phone. In this case, the system monitors the outside
Lines to determine if either party disconnects. Also, the Unsupervised Conference timer is
initiated when an Unsupervised Conference is established. Fifteen seconds prior to expiration of
the timer, a Warning Tone is provided and at expiration, the call disconnects.
If enabled, either party in an Unsupervised Conference can extend the Unsupervised Conference
beyond the timer expiration. The party enters the Timer Extension feature code and a digit “1to
“9” indicating the Timer extension multiplier. The system extends the timer based on the dialed
digit multiple of the Timer. For example, if the Unsupervised Conference timer is 5 minutes and
the user dials the digit 4, the timer will extend to 20 minutes (4 multiplied by 5 minutes).
Operation
iPECS IP & LDP Phones
1. Establish a conference with external parties as normal.
To set up an Unsupervised conference
2. Press the [CONF] button. The [CONF] button LED flashes to indicate the Unsupervised
Conference state.
1. Press the flashing [CONF] button.
To reenter the Unsupervised conference
Conference Party
1. Dial “# #”.
To extend the Unsupervised Conference Time from a connected party
2. Dial the Timer extension multiplier (1~9).
Conditions
1. The Unsupervised Conference Timer also applies to an external call placed by to a
DISA line in the system.
2. An Unsupervised Conference will be terminated if the system receives a disconnect
signal or the Unsupervised Conference Timer expires.
3. An Unsupervised Conference will not recall the user.
Programming
Keyset Admin.
NUMBERING
Unsupervised Conference Timer Extension (PGM 109-Button3)
STATION
Off Net Forward (PGM 111-Button 14)
SYSTEM
CO to CO UC Time Extension (PGM 160-Button 12)

Table of Contents

Other manuals for iPECS eMG80

Related product manuals