iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
83
SLT
1. Establish the first call.
To establish an ad-hoc a conference
2. Momentarily press the hook-switch, the connected party is placed on exclusive hold and
you receive dial tone.
3. Place the second call.
4. When completed adding parties, momentarily press hook-switch twice in 2 seconds to
connect all parties.
Conditions
1. The [CONF] button remains illuminated at the initiators phone for the duration of the
conference.
2. If the system receives a disconnect signal and no internal parties remain in the
conference, the conference is terminated and all parties are disconnected. If an
internal party is still connected when a disconnect signal is received, the connection to
remaining parties is maintained.
3. The normal Hold Recall process is applied to a conference on hold using the
Unsupervised Conference recall Timer for recall timing.
4. If while setting up a conference, system error tone is received, the initiator must press
the [CONF] button to regain Intercom dial tone; a SLT user must hook-flash.
5. A station that is busy, in DND or other non-idle state cannot be added to a conference.
6. A SLT user can establish a 3-party conference only, but can be a member of other
multi-party conferences.
7. In case of UCP, an MCIM is required to support 32-party conferences. With the MCIU,
the number of parties in the conference cannot exceed the number of MCIU channels.
Refer to the iPECS UCP Hardware Description and Installation Manual for MCIU
capacities. Note the capacity of the MCIU is reduced by approximately 1/3 when
transcoding of complex Codecs is needed.
Programming
Related Features
Automatic Speaker Select
Hold Recall
Unsupervised Conference
Broker Call
Conference Room
Hardware
MCIU or MCIM for more than 3-party conference for UCP
To Next Page
Loading...
