iPECS eMG80 - Hold; Automatic Hold

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
133
2.43 Hold
2.43.1 Automatic Hold
Description
While on an active outside call, the system will place the call on hold automatically if you press
the [FLASH], [CONF], {DSS/BLF} or other feature buttons. In addition, your station can be
programmed to support Line to Line Automatic Hold. In this case, pressing an outside Line button
while on an outside call will place the active call on hold and access the selected Line.
Operation
iPECS IP & LDP Phones
1. Press the desired feature button or {LINE}; the active call is placed in the Preferred Hold
state.
To use Automatic Hold while on an active outside call
Conditions
1. Outside Lines placed on hold with Automatic Hold are placed in the assigned Preferred
Hold.
2. There is no limit on the number of calls that can be placed on hold using Automatic
Hold.
Programming
Keyset Admin.
STATION
Automatic Hold (PGM 112-Button 2)
SYSTEM
Hold Preference (PGM 160-Button 7)
STATION DATA
Web Admin.
Common Attributes

Automatic Hold
SYSTEM DATA
System Attributes

Hold Preference
Related Features
 Hold Preference
 Hold Recall
Hardware
 iPECS IP or LDP Phone