iPECS eMG80 - Executive;Secretary Forward

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
106
3. Dummy dial tone can be provided during digit conversion.
4. There are two (2) special entries for configuring digit conversion:
− X: Mask Digit, any digit is accepted
− F: Ignore Digit
Programming
Keyset Admin.
SYSTEM
Digit conversion Table (PGM 270)
STATION
Digit conversion table index(114-Button 24-10)
CO
Digit conversion table index (141-Button20)
TABLE DATA
Web Admin.
Digit conversion Table (PGM 270)
STATION DATA
Common Attribute

Digit conversion table
CO LINE DATA
Common Attribute

Digit conversion table index
Related Features
Hardware
2.32 Alternative Route Selection for Digit conversion table
Description
This feature is enabled if there are several paths in order to connect toward a destination System
when a user use digit conversion feature.
If a selected path is not available for some reason (All Busy, Line Fault, etc) after digit conversion,
Alternative Route Selection (ARS) will connect calls using predefined designated path in digit
conversion table.
Operation
Conditions
If set, Alternative Route Selection operation is automatic.
1. ARS is optional and ARS digit in digit conversion table must be programmed to be
operational.
2. ARS digits should be contained in the CO Group Access Code
3. ARS can be used in coordination with Last Number Redial, Station Speed Dial, and
System Speed Dial.