iPECS eMG80 - LCD Display Format Control

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
416
6.9 Call Forward, Off-Net
Description
The System Attendant can forward incoming outside calls to a remote “Off-Net” location. Calls
forward via a Speed Dial bin. When a call is received, the system will automatically place a call
using the Speed Dial number, dialing the number and connecting the incoming call in an
Unsupervised conference.
Operation
System Attendant
1. Lift the handset or press the [SPEAKER] button.
To activate Off-Net Call Forward
2. Press the [FWD] button.
3. Dial ‘5’, the Off-Net Forward feature code.
4. Dial Line access code for the Line to be forward.
5. Dial the Speed Dial bin to use to place the outgoing (Off-Net) call, the LED of any Off Net
forwarded {LINE} button at the Attendant stations will flutter at a rate of 240 ipm while active.
1. Lift the handset or press the [SPEAKER] button.
To deactivate Off-Net Call Forward
2. Press the [FWD] button.
3. Dial “5”, Off-Net Forward code.
4. Dial Line access Code.
5. Dial ‘#’.
Conditions
1. The System Attendant can forward any Line, Line Group or all outside calls using the
appropriate Line access code. In addition, a Flex button assigned to a Line or group
may be employed in place of the Line access code to forward calls.
2. The conditions of the Unsupervised conference feature apply.
3. The conditions of the Call Forward Off-Net feature apply.
4. When enabled, calls that forward Off-net will receive the Off net forward prompt.
5. When enabled, calls that forward Off-net will receive the DTMF repeat tone.
6. To utilize Off-net forward of incoming calls on analog CO lines to another analog CO
line, a valid Open Loop Detect Timer should be assigned by programming for the
analog CO lines. This is to prevent CO line lock up in case the analog CO lines do not
provide proper disconnect signals for the system to detect.
7. To enable this feature, Day/Night/Timed COS of DISA COS (PGM 166) must be set on
the available value to allow the CO line (ex. The value is 1).