iPECS eMG80 - Net Call Transfer

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
255
Network Numbering Plan Table (PGM 324)
Network Feature Code Table (PGM 325)
NETWORKING DATA
Web Admin.
Net Basic Attributes
Net CO Line Attributes
Net Numbering Plan
Related Features
 Intercom (ICM) Call
 Speed Dial
Hardware
2.82.2.2 Net Call Transfer
Description
An active call, internal or outside, can be transferred to other stations across the Distributed
Network. Calls can be transferred across the network employing screened or unscreened transfer
in the same manner as a transfer within a system and is transparent to the user.
From a network perspective, the iPECS can use either the ‘Join’ or ‘Re-route’ signaling method to
complete a call transfer over the network. The Networking Transfer Mode assigns the method
that will be used and should be selected to match other systems connected in the private network.
 Join—an additional connecting path is needed to transfer the call to another Station.
 Routing—a new connecting path is used to transfer the call (the old connecting path of
the transferring station will be cleared).
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + Station Number + [HOLD/SAVE]
To assign a {NET DSS} button
1. Press the [TRANS/PGM] button.
To transfer an active call with Screened Call Transfer
2. Dial the station to receive the transfer.
3. At answer, announce the call.
4. Hang-up to complete the transfer.
Or,
1. Press the {NET DSS} button for the desired station.
2. At answer, announce the call.
3. Hang-up to complete the transfer.