iPECS eMG80 - Page 266

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
253
call routing; your dialed digits are compared with the Numbering Plan Table for routing. Station to
station calling, Call Transfers, Conferencing, Call Back, Call Waiting/Camp-on, Call Forward, and
DND operation are transparent to the users although conditions noted below may apply.
In addition, other features and functions as detailed in the following sections are available to you
as part of the distributed network environment.
Operation
Conditions
Operation of Distributed Networking is automatic when configured.
1. To use the networking features, the software lock-key installation is required. To obtain
a lock-key, contact your local Ericsson-LG Enterprise representative with the system
serial number.
2. Each station must have a unique station number of up to eight (8) digits, which is
based on their local system Station Numbering Plan.
3. The Network Numbering Plan permits 251 entries, allowing up to 251 iPECS systems
to be in a single distributed network environment.
4. The alternative route employs a Speed Dial number to place a call and is not a
Networked call. Thus, the Distributed Control Network features do not apply.
Programming
Keyset Admin.
SYSTEM Networking Basic Attribute (PGM 320)
Networking CO Line Attribute (PGM 322)
Network Numbering Plan Table (PGM 324)
Network Feature Code Table (PGM 325)
NETWORKING DATA
Web Admin.
Network Basic Attributes
Network Supplementary Attributes
Network CO Line Attributes
Network Numbering Plan
Network Feature Code Table
Related Features
Hardware