iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
285
2. Dial “41”, the code for setting the Wake-up Alarm.
3. Enter the Wake-up alarm index number, “1 to 5”.
4. Dial the desired 2-digit hour (24-hour mode), then 2-digit minute for alerting.
5. Enter Repeating type, “1” to “4”.
6. For the one-time alarm (repeating type 1), enter the date for the alarm as 2 digits for year,
month and day of the month.
7. Press the [HOLD/SAVE] button.
1. Press the [TRANS/PGM] button.
To erase a wake-up time from a Station, perform the following steps
2. Dial “42”.
3. Enter Wake-Up alarm index number, “1” to “5”.
4. Press the [HOLD/SAVE] button.
1. Lift the handset or press the [SPEAKER] button.
To stop the alarm notification
SLT
1. Lift the handset.
To register Wake-Up
2. Dial “*561”, the SLT Programming code, confirmation tone is heard.
3. Dial “41”, the set Wake-up code.
4. Dial the 2-digit hour and 2-digit minute for alerting.
5. Press Hook-flash to save.
1. Lift the handset.
To stop the alarm notification
1. Lift the handset.
To erase Wake-Up
2. Dial “*561”, the SLT Programming code, confirmation tone is heard.
3. Dial “42”, the erase Wake-up code.
4. Press Hook-flash.
Conditions
1. When registering or erasing an Alarm, iPECS IP and LDP phones can use the [VOL
UP]/[VOL DOWN] buttons to scroll between the Wake-up alarms and “#” can be used
to scroll through the repeating types.
2. The iPECS IP and LDP phones will display an asterisk near the time to indicate a
Wake-up alarm is set for the current day.
3. If you have all five Wake-up Alarms set, the Attendant cannot set a Wake-up alarm for
you. When the Attendant sets an alarm you it is assigned to the lowest Wake-up Alarm
index number (1-5) available for the station. If no Alarm index is available, the
To Next Page
Loading...
