iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
224
3. Dial the desired bin number (eMG80:2000-4999 / eMG800: 2000-9999 / UCP: 20000-
31999).
Attendant
1. Press the [TRANS/PGM] button.
To program a System Speed Dial number
2. Press the [SPEED] button.
3. Dial the Speed Dial bin number (eMG80:2000-4999 / eMG800: 2000-9999 / UCP: 20000-
31999).
4. Press the Line button or dial the Line access code.
5. Dial the number to be stored.
6. Press the [HOLD/SAVE] button.
7. If desired, enter a name, see alphanumeric entry chart under Station Speed Dial.
8. Press the [HOLD/SAVE] button.
1. Press the [DIR] soft button.
To enter a Station Speed Dial number using an LIP-8000/LIP-9000 series phone with soft
buttons
2. Press the [SPEED] soft button.
3. Press the [ADD] soft button.
4. Dial the Speed Dial bin number (eMG80:2000-4999 / eMG800: 2000-9999 / UCP: 20000-
31999).
5. Press the {LINE} button or dial the Line access code.
6. Dial the number to be stored.
7. Press the [HOLD/SAVE] button.
8. If desired, enter a name, see alphanumeric entry chart under Station Speed Dial.
9. Press the [HOLD/SAVE] button.
Conditions
1. Accessing an empty Speed Dial bin will return error tone.
2. A Speed Dial number uses a specific Line/or Line from a group assigned in the Speed
Dial bin. If the assigned Line is busy, a Line from the same group will be selected. If all
Lines in the group are busy, the user may queue for the next available Line.
3. All Speed Dial numbers are stored in memory protected from power loss.
4. For iPECS IP and LDP phones, a call placed with Speed Dial will appear under the
Flex button assigned for the Line, Line Group, or the general Line appearance [LOOP]
button, as appropriate for the station Flex button configuration.
5. The user may pre-select an outside Line for a Speed Dial number, overriding the
assignment in the Speed Dial bin.
6. A name can be entered for a Speed Dial number to permit access from the Dial-by-
Name directory.
7. If a Speed Dial number contains a “Dial Tone Detect” command (Flash as the first
To Next Page
Loading...
