iPECS eMG80 - Page 172

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
159
press one, to listen to the next message, press two, to delete message, press three, to forward
message, press four, to call the sender, press five, to return to main menu, press nine.”) is
played. This process is repeated until the last saved message is played and the "No Message”
prompt (“No Messages”) is played.
In addition to the options indicated in the prompt, you can record a memo, which is attached to
the current voice mail by dialing the digit 7. The current voice mail and memo can then be
forwarded to other iPECS users.
When you dial 9 in response to the “Number of Messages” prompt or during or at the end of a
message the “VM long Options” prompt is played.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + VM group + Mail-box (station) number + [HOLD/SAVE]
To assign a {VMAILBOX} Flex button
1. Lift the handset or press the [SPEAKER] button.
To retrieve Voice Mail locally
2. Press [MESSAGE/CALLBACK] button. The message contents summary is shown as
below.
ST CL VS VM FS MS
001 001 005 006 001 004
3. Dial digit “3” to select the integrated VM Messages to receive the “Mail Box & Password”
prompts sequentially.
4. Dial the Mail Box and corresponding password to receive the “Number of Messages”
prompt.
5. Dial desired option code.
6. At completion of session, hang-up to return to idle.
Or,
1. Lift the handset or press the [SPEAKER] button.
2. Press {VMAILBOX} button.
3. Dial the Mailbox password to receive the “Number of Messages” prompt.
4. Dial desired option code.
5. At completion of session, hang-up to return to idle.
1. During or after the New or Old Message option prompt, dial “7”.
To attach a memo to the current voice message
2. At the beep, record the memo.
3. Dial “*” to stop recording and store the memo.
4. During or after the New/Old option prompt, dial 4 to forward the message and memo.
To skip the date/time prompt while hearing