iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
162
Station VM Feature Usage: On
Digit Function
1 Play New message
2 Play Saved message
3 Play urgent message
4 Send a message
5 Personal options
6 Administrator options (administrator only)
7 Set Cancel/Fwd, available only for remote access
8 Mailbox Setting, "Mailbox Settings" prompt
9 VM Long options
# Drop, "Goodbye”
0 Attendant Call, Call to System Attendant.
Operation
1. At any time after the “Number of Messages” prompt, dial the digit to play a message. The
system initiates the selection providing any needed prompts.
To access a Message Retrieval option
Conditions
1. You must begin dialing within the CCR Analysis timer in response to a system prompt.
If the timer expires, the system will disconnect the call and you will receive error tone.
2. When the “call sender” option results in an external call, dialing restrictions will be
applied based on your Station COS (Class of Service).
3. If you remain off-hook after a call placed through the Voice Mail is complete, you will
be returned to the previous place in the Voice Mailbox. If you hangs up, the integrate
Voice Mail will recall you and, upon answer will play “Request Mailbox Number” prompt.
4. If your Mailbox is configured with Auto Save New Message, after listening to the
message, the message is stored and you must be expressly delete the message. To
minimize the potential for large amounts of unwanted stored messages, Auto Save
New message can be disabled then the message is deleted if not expressly saved.
Programming
Keyset Admin.
Auto Save New Message (PGM 161-Button 24-11)
SYSTEM DATA
Web Admin.
System Attributes Auto Save New Message, Station VM
Feature Usage
Related Features
Message Retrieval
To Next Page
Loading...
