iPECS eMG80 - Page 22

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
9
3. Dial Authorization Program Code “33”.
4. Dial Authorization Code (1 to 12 digits).
5. Momentarily press the Hook-switch, receive confirmation tone.
1. Dial the station number for the Station Authorization code or, for a System Authorization
Code, dial “*” or “*” and the Authorization table index.
To enter an Authorization Code when second dial tone is received
2. Dial the corresponding Authorization Code.
3. Momentarily press the Hook-switch.
4. Place your call as normal.
DISA
1. Dial the station number for a Station Authorization code or, for a System code, “*” or “*” and
the Authorization table index.
To enter an Authorization Code when second dial tone is received
2. Dial the corresponding Authorization Code.
3. Place call as normal.
System Attendant
1. Press the [TRANS/PGM] button.
To assign an Authorization Code
2. Dial Attendant Station Program code “031”.
3. Dial the Station number of a Station code or, for system code, “*” or “*” and the
Authorization table index.
4. Dial the corresponding Authorization Code.
5. Press the [HOLD/SAVE] button.
Conditions
1. When an outside DISA Line is marked for Authorization Code entry, the caller will hear
fast busy tone and must input a valid Authorization Code to continue. In case of an
entry error, the caller may retry entry of the code.
2. A DISA caller must enter a valid code within the number of attempts assigned as the
FAC (Forced Account Code) Retry Count. The station, if enabled, is placed to COS
(Class of Service) 7 after repeated failure attempts.
3. A user may enter an Authorization Code from any station to place an outside call using
Walking COS (Class of Service).
4. The eMG80/eMG800/UCP system provides memory for up to 500/2400/5200
Authorization codes, 140/1200/2400 for station codes and the remaining
360/1200/2800 are system codes.
5. Outside Line groups may be configured to require entry of a valid Authorization Code.
In this case, a second dial tone is provided when the Line group is accessed. If the
code entered is invalid, error tone is returned and the user must enter a valid code
within the FAC(Forced Account Code) Retry Count.