iPECS eMG80 - Page 221

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
208
Or,
1. Press the {ONE-TOUCH DISPLAY MESSAGE} button.
2. Dial auxiliary input, as desired.
3. Press the [HOLD/SAVE] button.
1. Press the flashing [FWD] button.
To cancel an active Display Message
1. Press the [TRANS/PGM] button.
To define the your Custom Text Message (00)
2. Dial “52”, the Custom Message program code.
3. Enter the Message contents, up to 24 characters using two (2) dial pad digits for each
character.
4. Press the [HOLD/SAVE] button, confirmation tone is received, your new Custom Text
Display Message is stored and the station returns to idle.
SLT
1. Lift the handset.
To activate a Display Message
2. Dial “*561”, the SLT Programming code.
3. Dial “51”, the Display Message code.
4. Dial Message number (“00”-“20”).
5. Dial auxiliary data as desired.
6. Momentarily press the hook-switch, confirmation tone is received.
1. Lift the handset.
To cancel an active Display Message
2. Dial “559”, the SLT Feature Cancel code.
1. Lift the handset.
To enter the User Custom Message (00)
2. Dial “*561”, the SLT Programming code.
3. Dial “52”, the Custom Message program code, confirmation is received.
4. Enter the Message contents, up to 24 characters.
5. Momentarily press the hook-switch, confirmation tone is received.
System Attendant
1. Press the [TRANS/PGM] button.
To activate Display Messages for other stations
2. Dial “051”, Attendant Display Message code.
3. Dial the station range, for a single station dial the same station number twice.
4. To view available messages, press [VOL UP]/[VOL DOWN] button.
5. Dial Message number (“00”-“20”).
6. Dial auxiliary data as desired.