iPECS eMG80 - Page 262

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
249
the alarm monitoring.
Or,
Press the {ALARM RESET} button.
[TRANS/PGM] + {FLEX} + “*76” + ## + Alarm type code + [HOLD/SAVE]
To assign a Flex button as an {Alarm Coverage} button to terminate the Alarm Signal
1. Dial the Flex Numbering Plan code “*76##” and “alarm type code”, confirmation tone is
received and the Alarm Signal is terminated. If the alarm condition is cleared, the system
will automatically rearm the alarm monitoring.
To terminate an Alarm Signal, while idle by using {Alarm Coverage}
Or,
Press the {Alarm coverage} button.
Conditions
1. The station must terminate the Alarm signal at their phone. However, a Main
Attendant can terminate the Alarm signal at the System Attendant.
2. When no station is assigned to receive an Alarm, the System Attendant will receive the
notification.
3. For Digital Line and SIP registration faults, the station in the Zone associated with first
Line of the BRI/E1/PRI interface or SIP channel receives the alarm signal.
4. The notification process for Emergency calls follows the Zone from which the call was
made and the System Attendant. The notified station can review the history of
Emergency calls only from the Zone. The System Attendant can review Emergency
Call history for all Zones.
Programming
Keyset Admin.
SYSTEM
Emergency Call Notify (PGM 163-Button 5)
DCOB Fault Notify (PGM163-Button 6)
SIP Registration Fault Notify (PGM163-Button 7)
ZONE DATA
Emergency Call Notify Station (PGM 439-Web only)
DCOB Fault Notify Station (PGM 439-Web only)
SIP Registration Fault Notify Station (PGM 439-Web only)
SYSTEM DATA
Web Admin.
Alarm Attributes Emergency Call Notify, DCOB Fault Notify,
SIP Registration Fault Notify
ZONE DATA Zone Attributes Emergency Call Notify Station, Emergency Call
Notify 2nd Station, DCOB Fault Notify Station, SIP Registration
Fault Notify Station